HobbyWing Telemetrie

HobbyWing Platinum V4 ESC has telemetry feature built-in in the Programming port. This allows telemetry data transmission to the unit. To allow the ESC telemetry, it is necessary to have updated ESC as the older firmware versions were not supporting it.

1 Telemetry Cable

To allow the telemetry data transmission special cable is required. This cable is available in our Eshop.

2 Interfacing

Connect the Telemetry cable to the primary Spektrum satellite port in the unit. Smaller Spirit units will utilize the one native Spektrum satellite port.

Servo connector of the Telem UNI cable should be connected to the ESC - programming port (P).

3 Spirit Settings

Power up the ESC and start the Spirit Settings as usually.

3.1 Telemetry activation

As the last step you have to set the ESC Telemetry in the Spirit Settings software.

Go to the Advanced/Telemetry settings and set the HobbyWing Platinum V4 option.

Then close the window and save the settings (CTRL+S). Finally, reconnect battery from the ESC.

From this moment, everything should work.

4 Displaying telemetry data

You can display telemetry data directly in your radio from now.

How to display the data is described in the integration guides:

• JETI Duplex
• FrSky Taranis & Horus
• Graupner HoTT

5 Supported models

Model	Battery Voltage	Battery Current	Consumed Capacity	ESC Temperature	RPM
Platinum 60A V4	✔	x	x	✔	✔
Platinum 80A V4	✔	✔	✔	✔	✔
Platinum 120A V4	✔	✔	✔	✔	✔
Platinum HV 130A V4	✔	✔	✔	✔	✔
Platinum HV 130A OPTO V4	✔	✔	✔	✔	✔
Platinum HV 160A V4	✔	✔	✔	✔	✔
Platinum HV 200A OPTO V4	✔	✔	✔	✔	✔

Consumed Capacity is calculated from the Current Consumption.