Телеметрия HobbyWing

В регуляторах HobbyWing Platinum v4 телеметрия доступна через порт программирования. Это позволяет передавать данные телеметрии в модуль Spirit. Чтобы пользоваться телеметрией, необходимо установить последнюю прошивку для вашего ESC, потому что старые версии не поддерживают эту функцию.

1 Телеметрийный кабель.

To allow the telemetry data transmission the Telem UNI cable is required. This cable is available in our Eshop.

We do not recommend to make this cable at home since improper connection will cause permanent damage of the unit. The Red wire must be internally disconnected always!

2 Interfacing

Connect the Telemetry cable to the primary Spektrum satellite port in the unit. Smaller Spirit units will utilize the one native Spektrum satellite port (μSpirit - SAT port).

Servo connector of the Telem UNI cable should be connected to the ESC - programming port (P).

3 Spirit Settings

Power up the ESC and start the Spirit Settings as usually.

3.1 Telemetry activation

As the last step you have to set the ESC Telemetry in the Spirit Settings software.

Go to the Advanced/Telemetry settings and set the HobbyWing Platinum V4 option.

Then close the window and save the settings (CTRL+S). Finally, reconnect battery from the ESC.

From this moment, everything should work.

4 Displaying telemetry data

You can display telemetry data directly in your radio from now.

How to display the data is described in the integration guides:

• JETI Duplex
• FrSky Taranis & Horus
• Graupner HoTT
• Spektrum Integration
• Futaba Telemetry

5 Supported models

Model	Battery Voltage	Battery Current	Consumed Capacity	ESC Temperature	RPM
Platinum 25A V4	✔	x	x	✔	✔
Platinum 40A V4	✔	x	x	✔	✔
Platinum 60A V4	✔	x	x	✔	✔
Platinum 80A V4	✔	✔	✔	✔	✔
Platinum 120A V4	✔	✔	✔	✔	✔
Platinum HV 130A V4	✔	✔	✔	✔	✔
Platinum HV 130A OPTO V4	✔	✔	✔	✔	✔
Platinum HV 160A V4	✔	✔	✔	✔	✔
Platinum HV 200A OPTO V4	✔	✔	✔	✔	✔

Consumed Capacity is calculated from the Current Consumption.