HobbyWing Telemetria
HobbyWing Platinum V4 ESC beépített telemetriai funkcióval rendelkezik a Programozási portban. Ez lehetővé teszi a telemetriai adatok továbbítását az egységbe. Az ESC telemetria engedélyezéséhez frissíteni kell az ESC-t, mivel a régebbi firmware verziók nem támogatták.
Contents
1 Telemetriai kábel
A telemetriai adatok továbbításához a Telem UNI kábel szükséges. Ez a kábel elérhető az Eshop-ban Eshop.
We do not recommend to make this cable at home since improper connection will cause permanent damage of the unit. The Red wire must be internally disconnected always!
2 Interfacing
Connect the Telemetry cable to the primary Spektrum satellite port in the unit. Smaller Spirit units will utilize the one native Spektrum satellite port (μSpirit - SAT port).
Servo connector of the Telem UNI cable should be connected to the ESC - programming port (P).
3 Spirit Settings
Power up the ESC and start the Spirit Settings as usually.
3.1 Telemetry activation
As the last step you have to set the ESC Telemetry in the Spirit Settings software.
Go to the Advanced/Telemetry settings and set the HobbyWing Platinum V4 option.
Then close the window and save the settings (CTRL+S). Finally, reconnect battery from the ESC.
From this moment, everything should work.
4 Displaying telemetry data
You can display telemetry data directly in your radio from now.
How to display the data is described in the integration guides:
5 Supported models
|
Model |
Battery Voltage |
Battery Current |
Consumed Capacity |
ESC Temperature |
RPM |
|---|---|---|---|---|---|
| Platinum 25A V4 | ✔ | x | x | ✔ | ✔ |
| Platinum 40A V4 | ✔ | x | x | ✔ | ✔ |
| Platinum 60A V4 | ✔ | x | x | ✔ | ✔ |
| Platinum 80A V4 | ✔ | ✔ | ✔ | ✔ | ✔ |
| Platinum 120A V4 | ✔ | ✔ | ✔ | ✔ | ✔ |
| Platinum HV 130A V4 | ✔ | ✔ | ✔ | ✔ | ✔ |
| Platinum HV 130A OPTO V4 | ✔ | ✔ | ✔ | ✔ | ✔ |
| Platinum HV 160A V4 | ✔ | ✔ | ✔ | ✔ | ✔ |
| Platinum HV 200A OPTO V4 | ✔ | ✔ | ✔ | ✔ | ✔ |
Consumed Capacity is calculated from the Current Consumption.
