Jive Telemetria

A Kontronik Jive ESC rendelkezik telemetriai funkcióval a dedikált aljzatban (JMP címke). Ez teszi lehetővé a telemetriai adatok továbbítását az egység felé.

1 Telemetriai vezeték

A telemetriai adatátvitel engedélyezéséhez a Telem UNI vezeték szükséges. Ez a kábel elérhető az A telemetriai adatátvitel engedélyezéséhez a Telem UNI kábel szükséges. Ez a kábel elérhető az Eshop-ban.

It is necessary to modify the cable! Swap orange and red wires in the servo connector of the Telem UNI cable. The Orange wire must be in the middle.

2 Interfacing

Connect the Telemetry cable to the primary Spektrum satellite port in the unit. Smaller Spirit units will utilize the one native Spektrum satellite port.

Do not connect the Telem UNI cable without required modification! This can damage the unit permanently.

Servo connector of the Telem UNI cable should be connected to the ESC - programming port (JMP).

3 Spirit Settings

Power up the ESC and start the Spirit Settings as usually.

3.1 Telemetry activation

As the last step you have to set the ESC Telemetry in the Spirit Settings software.

Go to the Advanced/Telemetry settings and set the Kontronik Jive option.

Then close the window and save the settings (CTRL+S). Finally, reconnect battery from the ESC.

From this moment, everything should work.

4 Displaying telemetry data

You can display telemetry data directly in your radio from now.

How to display the data is described in the integration guides:

• JETI Duplex
• FrSky Taranis & Horus
• Graupner HoTT
• Spektrum Integration

5 Supported models

Model	Battery Voltage	Battery Current	BEC Voltage	Consumed Capacity	ESC Temperature	RPM
JIVE 80+ HV	✔	✔	✔	✔	✔	✔
JIVE 80+ LV	✔	✔	✔	✔	✔	✔
JIVE 100+ LV	✔	✔	✔	✔	✔	✔
JIVE 120+ HV	✔	✔	✔	✔	✔	✔

Consumed Capacity is calculated from the Current Consumption.