TelMe Telemetria

Gli ESC Kontronik utilizzano uno speciale connettore a 5 pin per la trasmissione dei dati di telemetria all'unità. Per consentire la telemetria ESC, è necessario aver aggiornato l'ESC almeno alla versione firmware 1.13 (JIVE PRO) e 4.14 (KOSMIK). Le versioni precedenti non supportano il protocollo TelMe.

1 Telemetry Cable

To allow the telemetry data transmission the Telem KONTRONIK v2 cable is required. This cable is available in our Eshop.

We do not recommend to make this cable at home since improper connection will cause permanent damage of the unit.

2 Interfacing

Connect the Telemetry cable to the primary Spektrum satellite (SAT1) port in the unit. Smaller Spirit units will utilize the one native Spektrum satellite port (μSpirit - SAT port).

5-pin JST connector of the Telem KONTRONIK v2 cable should be connected to the ESC. In case of Kontronik KOSMIK please use port in the middle.

3 Spirit Settings

Power up the ESC and start the Spirit Settings as usually.

3.1 Telemetry activation

As the last step you have to set the ESC Telemetry in the Spirit Settings software.

Go to the Advanced/Telemetry settings and set the Kontronik TelMe option.

Then close the window and save the settings (CTRL+S). Finally, reconnect battery from the ESC.

From this moment, everything should work.

4 Displaying telemetry data

You can display telemetry data directly in your radio from now.

How to display the data is described in the integration guides:

• JETI Duplex
• FrSky Taranis & Horus
• Graupner HoTT
• Spektrum Integration
• Futaba Telemetry

5 Supported models

Model	Battery Voltage	Battery Current	BEC Voltage	Consumed Capacity	ESC Temperature	RPM
KOLIBRI 140 LV	✔	✔	✔	✔	✔	✔
JIVE PRO 80+ HV	✔	✔	✔	✔	✔	✔
JIVE PRO 120+ HV	✔	✔	✔	✔	✔	✔
KOSMIK 160 HV	✔	✔	✔	✔	✔	✔
COOL KOSMIK 160 HV	✔	✔	✔	✔	✔	✔
KOSMIK 200 HV	✔	✔	✔	✔	✔	✔
COOL KOSMIK 200+ HV	✔	✔	✔	✔	✔	✔
COOL KOSMIK 200 HV GOLD	✔	✔	✔	✔	✔	✔