Wifi-Link
1 FEATURES
Power supply: 3.3V - 15V
Weight: 7g
Dimension: 21x32x5.5mm
Operating range: up to 50 meters
Modes: AP, AP+Client, Client
Standard: 802.11b/g/n
Encryption: Open, WEP, WPA, WPA2
Configuration: Web Interface
Power consumption: 80 – 350mA
Supported devices:
- Android (available on the Google Play)
- All smartphones, tablets, smart TV with Web Browser
- PC
- Mac
Support for Firmware Updates.
Web based Spirit Settings app in the module!
2 CONNECTION
| VCC | Positive powering lead: 3.3V – 15V |
| GND | Ground powering lead |
| RX | Communication lead; SYS port |
| TX | Communication lead; SYS port |
NOTE
TX wire must be always closer to the SYS label RX wire must be always in the center pin of the SYS port
VCC and GND can be connected to any port, except ELE/PIT/AIL and SYS. It can be connected to a receiver port too. If powered from a separate battery, GND must be connected with the unit's power source.
Do not connect communication cable to the power supply! It can be connected only to the SYS port.
3 CONFIGURATION
Spirit Wifi-Link offers you user friendly configuration from any device that support WiFi connection and web browser.
To open it, you can proceed in this way:
- Connect to the Wifi module.
Default SSID (Wifi site name): Spirit Wifi-Link.
The module is by default in the Acess Point mode.
You can connect to the AP directly in a normal way.
After connection, your device will get IP address automaticaly.
- Open your web browser.
Usually any modern web browser with JavaScript support can be used.
