Scorpion Telemetry

From Spirit System Manual
Jump to: navigation, search
This page contains changes which are not marked for translation.

Other languages:
čeština • ‎Deutsch • ‎English • ‎español • ‎français • ‎italiano • ‎русский

Scorpion Tribunus ESC has telemetry feature built-in in the Programming port. This allows telemetry data transmission to the unit.

1 ESC configuration

To enable the ESC telemetry, it is necessary to set the Unsolicited telemetry mode in your ESC. With other modes the telemetry will not work. Change Communication protocol to Unsc Telem in the Scorpion Tribunus software. For this purpose Scorpion V link II Cable is needed.


2 Telemetry Cable

To allow the telemetry data transmission the Telem UNI cable is required. This cable is available in our Eshop.


3 Interfacing

Connect the Telemetry cable to the primary Spektrum satellite port in the unit. Smaller Spirit units will utilize the one native Spektrum satellite port.


Servo connector of the Telem UNI cable should be connected to the ESC - programming port.


4 Spirit Settings

Power up the ESC and start the Spirit Settings as usually.

4.1 Telemetry activation

As the last step you have to set the ESC Telemetry in the Spirit Settings software.

Go to the Advanced/Telemetry settings and set the Scorpion Tribunus option.


Then close the window and save the settings (CTRL+S). Finally, reconnect battery from the ESC.

From this moment, everything should work.

5 Displaying telemetry data

You can display telemetry data directly in your radio from now.

How to display the data is described in the integration guides:

6 Supported models


Battery Voltage

Battery Current

BEC Voltage

Consumed Capacity

ESC Temperature


Scorpion Tribunus 06-120A (SBEC)
Scorpion Tribunus 06-120A (OPTO)
Scorpion Tribunus 14-200A (SBEC)