Difference between revisions of "Spektrum PWM connection/en"
From Spirit System Manual
(Updating to match new version of source page) |
(Importing a new version from external source) |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
<languages /> | <languages /> | ||
| − | This table is describing connection of the Spektrum | + | This table is describing connection of the Spektrum AR610 receiver. |
Because labels are same between other receivers you can use it also for other AR receivers. | Because labels are same between other receivers you can use it also for other AR receivers. | ||
=== PWM Wiring === | === PWM Wiring === | ||
| Line 23: | Line 23: | ||
<p></p> | <p></p> | ||
{{Info|[[File:Info.png|18px|]] Special cable which ends with 3 servo connectors must be connected in the way, that these wires are always closer to the port labels.}} | {{Info|[[File:Info.png|18px|]] Special cable which ends with 3 servo connectors must be connected in the way, that these wires are always closer to the port labels.}} | ||
| − | ESC should be connected to the THRO port. | + | *ESC should be connected to the THRO port. |
| + | |||
| + | *If External BEC is used, you can connect it to a free port in the receiver. | ||
Latest revision as of 21:19, 24 January 2017
This table is describing connection of the Spektrum AR610 receiver. Because labels are same between other receivers you can use it also for other AR receivers.
PWM Wiring
| UNIT | RECEIVER |
| RUD | RUDD |
| AUX | GEAR |
| ELE/PIT/AIL | ORANGE wire to AILE RED wire to AUX 1 BROWN wire to ELEV |
Servo connectors are connected always with Orange wire closer to the labels (in the receiver and unit as well).
- ESC should be connected to the THRO port.
- If External BEC is used, you can connect it to a free port in the receiver.
