Difference between revisions of "CC Phoenix Edge RPM output/it"
From Spirit System Manual
(Created page with "Puoi farlo facilmente con un ago.") |
(Created page with "Disposizione dei fili") |
||
| Line 14: | Line 14: | ||
[[File:cc-sensor.jpg|300px|]] | [[File:cc-sensor.jpg|300px|]] | ||
| − | ; | + | ; Disposizione dei fili |
: White wire: RPM Output Signal (PIT pin) | : White wire: RPM Output Signal (PIT pin) | ||
: Yellow wire: Throttle signal (AUX1 port) | : Yellow wire: Throttle signal (AUX1 port) | ||
Revision as of 12:42, 14 January 2021
Gli ESC di Castle Creations Phoenix sono dotati di un cavo RPM che fornisce il segnale al governatore esterno. Quindi non è necessario fare altro se non collegare correttamente i cavi e spegnere il Governo interno dell'ESC.
1 Modifica richiesta
Per l'utilizzo con le unità Spirit è necessaria una piccola modifica del cavo RPM.
- Spostare il cavo bianco al centro nel connettore servo.
- Puoi farlo facilmente con un ago.
- Disposizione dei fili
- White wire: RPM Output Signal (PIT pin)
- Yellow wire: Throttle signal (AUX1 port)
- Red wire: BEC Voltage (AUX1 port)
- Brown wire: Ground (AUX1 port)
Connect the cables according the photo now.
2 Changing ESC settings
It is very important to change ESC mode so that internal Governor is disabled. This can be done by Castle Link software.
After this, you can enable Governor in the Spirit unit.
3 Governor Settings
In the Spirit Settings open the General - Throttle/Governor window and set the following:
- Throttle Frequency: 60Hz.
- Throttle Range - Min.: 1060 us.
- Throttle Range - Max.: 1940 us.
