Difference between revisions of "CC Phoenix Edge RPM output/ru"
From Spirit System Manual
(Created page with "Необходимая переделка") |
(Created page with "Для использования со Spirit требуется небольшая модификация разъема RPM.") |
||
| Line 7: | Line 7: | ||
== Необходимая переделка == | == Необходимая переделка == | ||
| − | + | Для использования со Spirit требуется небольшая модификация разъема RPM. | |
*Move the White cable to the middle in the Servo connector. | *Move the White cable to the middle in the Servo connector. | ||
Revision as of 08:29, 16 October 2018
Регуляторы Castle Creations Phoenix имеют вывод со встроенного датчика оборотов. Остается только подключить этот провод и отключить встроенный гувернер.
1 Необходимая переделка
Для использования со Spirit требуется небольшая модификация разъема RPM.
- Move the White cable to the middle in the Servo connector.
- You can do so with a needle easily.
- Wire layout
- White wire: RPM Output Signal (PIT pin)
- Yellow wire: Throttle signal (AUX1 port)
- Red wire: BEC Voltage (AUX1 port)
- Brown wire: Ground (AUX1 port)
Connect the cables according the photo now.
2 Changing ESC settings
It is very important to change ESC mode so that internal Governor is disabled. This can be done by Castle Link software.
After this, you can enable Governor in the Spirit unit.
3 Governor Settings
In the Spirit Settings open the General - Throttle/Governor window and set the following:
- Throttle Frequency: 60Hz.
- Throttle Range - Min.: 1060 us.
- Throttle Range - Max.: 1940 us.
