Difference between revisions of "Spektrum PWM connection/en"
From Spirit System Manual
(Updating to match new version of source page) |
(Importing a new version from external source) |
||
| Line 24: | Line 24: | ||
{{Info|[[File:Info.png|18px|]] Special cable which ends with 3 servo connectors must be connected in the way, that these wires are always closer to the port labels.}} | {{Info|[[File:Info.png|18px|]] Special cable which ends with 3 servo connectors must be connected in the way, that these wires are always closer to the port labels.}} | ||
ESC should be connected to the THRO port. | ESC should be connected to the THRO port. | ||
| + | |||
| + | *If External BEC is used, you can connect it to a free port in the receiver. | ||
Revision as of 21:18, 24 January 2017
This table is describing connection of the Spektrum AR6210 receiver. Because labels are same between other receivers you can use it also for other AR receivers.
PWM Wiring
| UNIT | RECEIVER |
| RUD | RUDD |
| AUX | GEAR |
| ELE/PIT/AIL | ORANGE wire to AILE RED wire to AUX 1 BROWN wire to ELEV |
Servo connectors are connected always with Orange wire closer to the labels (in the receiver and unit as well).
ESC should be connected to the THRO port.
- If External BEC is used, you can connect it to a free port in the receiver.
